1- Visual inspection: Checks for missing or any burning on resistance. 2- Using Digital Multimeter: You can check the resistor resistance by selecting the ohm range in the digital multimeter, If the resistor is in circuit, you will generally have to remove the resistor so you are testing only the resistor value and not the other components in the circuit. Connect test probes across the two points of the resistor as shown in the photo, polarity isn’t important, value of resistance shown is 9.86 kΩ. Note: All resistors have a specific tolerance rating. The tolerance rating is marked by a color band on the end of the resistor’s body, normally the band is gold indicating 5 % tolerance. If the tolerance band is silver, then the rating is 10 %. How to test SMD Resistors: Because of the small size of SMD resistors, there is often not room for the traditional color band code to be printed on them. Therefore, new resistor SMD codes were developed. The most commonly seen codes are the three